CRADLEPOINT CBR400| USER MANUAL Firmware ver. 3.3.0
© 2011 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 12
3 QUICK START
3.1 Basic Setup
Your router requires an internet source. Insert a supported USB or ExpressCard modem, connect a Cable or DSL
modem to the Ethernet port (this requires a settings change because the Ethernet port is not set as WAN by
default; see ―Ethernet Port Configuration‖ in Network Settings → WiFi / Local Networks), or connect to an
available WiFi source (see Internet → WiFi as WAN Settings to enable WiFi as WAN). For Failover/Failback
functionality, you will need at least two of these sources (for example: one Ethernet source and one USB modem).
1
Connect the 12v DC power adapter to the router and a power source. Flip the power switch to the ON position; this
should illuminate the green Power Status LED.
1
Data Modem Not Included. This Product Requires an Activated Data Modem or Phone with Data Plan for Full Functionality. See your Cellular/3G/4G Service Provider for Details
on Coverage and Data Plan Options
To Next Page
Loading...
