CRADLEPOINT CBR400| USER MANUAL Firmware ver. 3.3.0
© 2011 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 73
6.7.3 Local Network Interfaces
Each LAN type—WiFi, Ethernet, and VLAN—has a separate section with configuration options. Unless the default
configuration is sufficient, YOU MUST CONFIGURE EACH INTERFACE SEPARATELY in order to create the desired
interface options for a network. You can then select these interfaces to add to a network in the Local Network Editor
(see above).
Select from the following tabs:
Wireless (WiFi) Network Settings
Ethernet Port Configuration
VLAN Interfaces
Wireless (WiFi) Network Settings
The CBR400 can broadcast two SSIDs
(service set identifiers — the names for WiFi
networks). One primary WiFi network is
enabled by default, while you may have
enabled a second guest network when using
the First Time Setup Wizard. You have the
ability to change the settings for either of
these networks.
Wireless Radio: Enable/Disable. (Default:
Enabled). Leave enabled unless you don‘t
want any WiFi networks broadcast from your router.
Select a WiFi network and click Edit to change the settings.
To Next Page
Loading...
