Craftex CX614 - User Manual

Questions and Answers

T
Tonya SmithSep 5, 2025
Why is the board edge curved after using my Craftex Power Tool?
- J
  josemaloneSep 6, 2025
  This can happen if the board isn't held with the same pressure on the infeed and outfeed table during the cut; ensure you hold the board with consistent pressure as it moves over the cutterhead. Also, if the board has too much bow or coil along its length, take limited cuts to remove the high spots before a full pass. Surface plane one face so there is a good surface to place along the fence. It should take 3 to 5 passes to get a perfect edge depending on the state of the board and the depth of cut.
A
ariddleSep 6, 2025
Why is my Craftex Power Tool causing chipped or ripped out pieces?
- M
  Melissa BarrettSep 6, 2025
  This issue can be caused by knots or incompatible grain direction in the wood. Check the workpiece for knots and grain; clean stock should be used. Also, nicked or broken cutter inserts can be the problem; turn or replace the cutter insert. Feeding the workpiece too fast can also cause this; reduce the feed rate. Finally, taking too deep of a cut can cause chipping; take a smaller depth in cut, especially when using hard wood.
A
Amanda PatrickSep 7, 2025
Why does my Craftex Power Tool leave rough cutter marks on the board?
- A
  Adam GarciaSep 7, 2025
  This can happen if you are feeding the workpiece too fast; reduce the feed rate. It can also occur if the cutter inserts are not on the same height in the cutterhead; wipe clean and fix the cutter inserts so they are set on the same level as the cutterhead.
J
Janet OlsenSep 7, 2025
Why is the infeed table difficult to modify on my Craftex Power Tool?
- W
  William RichardsonSep 7, 2025
  The table lock may be busy or partly busy. Release the table lock fully.
S
Scott HodgesSep 8, 2025
Why does my Craftex Power Tool leave lines or ridges on the board?
- W
  webbjoshuaSep 9, 2025
  A nicked, blunt, or chipped cutter insert can cause this. Turn or get a new cutter insert.
M
marywhitakerDec 3, 2025
How to fix vibration in Craftex Lathe?
C
Christopher CooperDec 1, 2025
Why is my Craftex Lathe stalling?