ConnectHoseandWater Supply to Pump
NOTICE DO NOTrun the pump without the water supply
connectedand turned on.
= Damageto equipmentresultingfrom failureto followthis
instructionwill voidwarranty.
4. Runwater through garden hosefor 30 seconds to flush
it of debris. Turn off water.
NOTICE DO NOTsiphon standing water for the water
supply. Use ONLYcold water (less than 100°F).
5. Connectgarden hose (not to exceed50 feet in length) to
water inlet. Tighten by hand.
NOTICE Remove and discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1. Uncoil high pressure hose and attachone end of hoseto
baseof spray gun. Tighten by hand.
,& WARNRNG The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
= NEVERconnect high pressure hose to nozzleextension.
= Keephigh pressure hose connectedto pump and spray gun
while system is pressurized.
= Always be certain spray gun, nozzlesand accessoriesare
correctly attached.
2. Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
.
Beforeconnectinggarden hose to water inlet, inspect
inlet screen (A). Cleanscreen if it contains debris or have
it replacedif damaged.DO NOTrun pressurewasher if
inlet screenisdamaged or missing.
NOTICE Using a OneWay Valve (vacuumbreakeror check
valve) at pump inlet could cause pump or inlet connector
damage.
= ThereMUSTbeat leasttenfeetof unrestrictedgardenhose
betweenthe pressurewasherinletandanydevice,suchasavacu-
umbreakeror checkvalve.
• Damageto equipment resulting from failure to follow this instruc-
tion will void warranty.
,& WARNING Risk of eye injury.
Spray could splash back or propel objects
resulting in serious injury.
.
• Always wear indirect vented (chemical splash) safety goggles
markedto comply with ANSI Z87.1 when using or in vicinity of
this equipment.
• NEVERsubstitute safety glasses or dry-condition goggles for
indirect vented safety goggles.
Turn ONthe water, press red button (B) on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
Checklist BeforeStarting Engine
Reviewthe unit to ensure you have performed all of the
following:
1. Besure to read Safety Rules and Operationsections
before using the pressure washer.
2. Makesure handleis in place and secure.
3. Checkthat oil has beenadded to proper level in engine
crankcase.
4. Add proper fuel to fuel tank.
5. Checkfor proper hose connections (high pressure and
water supply) and that there are no kinks, cuts, or
damageto the high pressure hose.
6. Provide proper water supply (not to exceed100%).
11
To Next Page
Loading...
