ENGINETECHNICALiNFORMATiON
This is a single cylinder, overheadvalve (OHV), air cooled
engine, it is a low emissions engine.
In the State of California, Model 110000 enginesare certified
by the California Air Resources Boardto meet emissions
standardsfor 125 hours. Such certification does not grant
the purchaser, owner or operator of this engine any
additional warranties with respect to the performance or
operational life of this engine. The engine is warranted solely
according to the product and emissions warranties stated
elsewherein this manual.
Power Ratings
Thegross power rating for individual gas engine models is
labeled in accordancewith SAE(Society of Automotive
Engineers)codeJ1940 (Small Engine Power & Torque
Rating Procedure), and rating performance has been
obtained and corrected in accordancewith SAEJ1995
(Revision 2002-05). Torquevalues are derived at 3060 RPM;
horsepower values are derived at 3600 RPM.Net power
values aretaken with exhaustand air cleaner installed
whereas gross power values are collected without these
attachments.Actual gross engine power will be higher than
net engine power and is affected by, among other things,
ambient operating conditions and engine-to-engine
variability. Given the wide array of products on which engines
are placed, the gasengine may not developthe ratedgross
power when used in a given pieceof power equipment.This
difference is due to a variety of factors including, but not
limited to, the variety of engine components (air cleaner,
exhaust, charging, cooling, carburetor, fuel pump, etc.),
application limitations, ambient operating conditions
(temperature, humidity, altitude), and engine-to-engine
variability. Due to manufacturing and capacity limitations,
Briggs & Stratton may substitute an engine of higher rated
power for this Series engine.
PRODUCTSPECiFiCATiONS
PressureWasherSpecifications
Max Outlet Pressure ...................... 2,700 PSI*
Max Flow Rate............................. 2.3 GPM
DetergentMix ........................ Use as directed
Water Supply Temperature .......... Not to exceed100°F
Engine Specifications
Bore............................... 2.58 in. (65.6mm)
Stroke ............................. 2.04 in. (51.8mm)
Displacement ........................ 10.69in. (175cc)
SparkPlug
Type:...................... Briggs & Stratton 692051
SetGapTo: ...................... 0.020inch (0.50mm)
ArmatureAir Gap: ........... 0.010-0.014in.(0.25-0.36mm)
Valveclearancewith valvesprings installedand piston 1/4 in.
(6 mm) pasttop deadcenter(checkwhenengineiscold).
Intake.................... 0.004-0.008in.(0.10-0.20mm)
Exhaust .................. 0.004-0.008in.(0.10-0.20mm)
FuelCapacity............................... 1.6Quarts
0il Capacity........................ 20 Ounces(0.6 liter)
NOTICE For practical operation, the engine load should not
exceed85% of ratedpower. Enginepower will decrease
3-1/2% for each1,000 feet (300 meters) above sealeveland
1% for each 10° F (5.6° C) above77° F (25° C). It should
operatesatisfactorily at an angle up to 15°.
* This pressure washer is rated in accordanceto the
PressureWasher Manufacturers Association (PWMA)
standard PW101 (Testing and Rating Performance of
PressureWashers).
17
To Next Page
Loading...
