Craftsman 580.752521 - Operation; How to Use Your Pressure Washer; To Start Your Pressure Washer

HOWTO USEYOURPRESSUREWASHER
If you have any problems operating your pressure washer,
pleasecallthe pressure washer helpline at 1-800-222-3136.
PressureWasherLocation
PressureWasher Clearance
_1_WARNING Exhaust heat/gasescould ignite
combustibles, structures or damagefuel tank
causing afire, resultingin death,serious injury
and/or property damage.
= Keepat least5 ft. (152cm)clearanceonall sidesof pressure
washerincludingoverhead.
Placepressure washer outdoors in an area that will not
accumulate deadly exhaust gas. DO NOTplace pressure
washer where exhaust gas (A) could accumulate and enter
inside or be drawn into a potentially occupied building.
Ensureexhaustgas is kept awayfrom any windows, doors,
ventilation intakes, or other openingsthat can allow exhaust
gasto collect in aconfined area. Prevailing winds and air
currents should be taken into considerationwhen positioning
_ressurewasher.
_1_WARNING Running engine gives off carbon
monoxide, an odorless, colorless, poison gas.
_ Breathing carbon monoxide could result in death,
serious injury, headache, fatigue, dizziness,
vomiting, confusion, seizures, nausea or fainting.
• Operatethis product ONLY outdoors.
= Keepexhaustgas from entering a confined areathrough
windows, doors, ventilation intakes, or other openings.
• DO NOToperatethis product insideany building, carport,
porch, mobile equipment, marine applications, or enclosure,
even if windows and doors are open.
To Start Your Pressure Washer
To start your engine-powered pressurewasher for the first
time, follow these instructions step-by-step. This information
alsoapplies wheneveryou start the engine after you havelet
the pressure washer sit idle for at leasta day.
1. Placepressurewasher outside nearan water source
capableof supplying water at a flow rate greater than
3.3 gallons per minute and no less than 20 PSi at
pressurewasher end of garden hose.
2. Checkthat high pressure hose is tightly connected to
spray gun and pump. SeeAssembly for illustrations.
3. Makesure unit is in a levelposition.
4. Connectgarden hose to water inlet on pressurewasher
pump.
NOTICE DO NOTrun the pump without the water supply
connectedand turned on.
= Damageto equipmentresultingfromfailureto followthis
instructionwill voidwarranty.
5. Turn ONthe water, press red button on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
6. Attach nozzleextension to spray gun. Tighten by hand.
.
.
Pull backon collar of nozzleextension, insert selector
nozzleand releasecollar. Tug on selector nozzleto make
sure it is securelyin place. See How to UseSelector
Nozzle.
Pushengine rocker switch (!) to on position (I or ON).
12