2-1N-1SoapSystem
AWARNING Chemical Burn Hazard.
j:_ Chemicalscould cause burns resulting in death,
serious injury,and/or property damage.
• DONOTusecausticliquidwithpressurewasher.
• UseONLYpressurewashersafedetergents/soaps.Followall
manufacturersinstructions.
Cleaning and Applying Detergentwiththe
Project Pro(E)PerfectMW MSiphon
To apply undiluted detergent using the blue
PerfectMixTM siphon, follow these steps:
1. Reviewuse of selector nozzle.
2. Attach PerfectMWMsiphon hose to
pump and PerfectMixTM concentrate
bottle. //
NOTICE Contact with the hot muffler could damage
detergent siphoning tube.
• When inserting the siphon into a detergent solution bottle, route
the tube so as to keep it from inadvertently contacting the hot
muffler.
3. Make sure SOAPspray pattern nozzleis selected on
selector nozzle.
NOTICE Detergent cannot be applied with the MAX,
GENERAL,DELICATEor FLUSHspray pattern nozzles.
4. Make sure garden hose is connectedto water inlet.
Checkthat high pressure hoseis connected to spray gun
and pump. Turn on water.
NOTICE You must attach all hoses before you start the
engine.
• Starting the engine without all the hoses connected and without
the water turned ON could damagethe pump.
• Damageto equipment resulting from failure to follow this
instruction will void warranty.
5. Start enginefollowing instructions How to Start Your
Pressure Washer.
6. Apply detergent to a dry surface, starting at lower
portion of areato be washedand work upward, using
long, even,overlapping strokes.
7. Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapplyas neededto prevent
surfacefrom drying. DONOTallow detergentto dry on
(prevents streaking).
Cleaning and Applying Detergentwith
the Standard Clear Siphon
To apply diluted detergent using the
standard clear siphon tube, follow these
steps:
1. Reviewuseof selector nozzle.
2. Attach clear siphon hoseto barbedfitting on pump.
3. Mix detergent solution as required by job.
4. Placesmall filter end of clear siphoning tube into
container with diluted solution as described above.
NOTICE DO NOTinsert standard siphon hose in Extreme
Concentrate.Failure to dilute concentratewill causeexcessive
application and consumption of solution.
NOTICE Makesure the filter is fully submerged in fluid
while applying solution.
NOTICE Contact with the hot muffler could damage
detergent siphoning tube.
• When inserting the siphon into a detergent solution bottle, route
the tube so as to keep it from inadvertently contacting the hot
muffler.
5. Makesure SOAPspray pattern nozzleis selectedon
selector nozzle.
NOTICE Detergentcannot be applied with the MAX,
GENERAL,DELICATEor FLUSHspray pattern nozzles.
6. Makesure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
NOTICE You must attach all hoses before you start the
engine.
• Starting the enginewithout all the hoses connectedand without
the water turned ONcould damagethe pump.
• Damageto equipment resulting from failure to follow this
instruction will void warranty.
7. Start engine following instructions How to Start Your
Pressure Washer.
8. Apply detergentto a dry surface, starting at lower
portion of areato be washed and work upward, using
long, even, overlapping strokes.
9. Allow detergent to "soakin" for 3-5 minutes before
washing and rinsing. Reapplyas neededto prevent
surfacefrom drying. DO NOTallow detergent to dry on
(prevents streaking).
NOTICE You must flush the detergent siphoning system
after each use by placing the filter into a bucketof clean
water, then run the pressurewasher in low pressure for 1-2
minutes.
15
To Next Page
Loading...
