Monitoring lights oil pressure and battery
charging current
Make sure that the monitoring lights for oil pressure
and charging current are extinguished and that cooling
water is coming out of the exhaust line. If not so, stop
the engine IMMEDIATELY.
Never turn the electric main switch to
the ‘off’ position when the engine is
running.
Also: do not turn the starter switch to
the ‘start’ position when the engine is
running. This may cause serious damage
to the starter motor.
Electric engine stop
Before stopping the engine, shift the throttle lever
back to its neutral position, place the gearbox lever
into the neutral position and let the engine idle during
a few moments. Turn the starter switch to the far left
position of ‘stop’. After a long trip it is recommended
to have the engine idling for a few minutes, before
putting it to full stop.
When the engine has stopped, turn the key one step
to the right, to the ‘off’ position.
Close the seacock of the raw water inlet and turn the
main electrical switch to the off position, if the engine
will not be used during a prolonged period of time.
Manual stop
Should the engine not respond to the stop command
by means of the starter key, keep the black button on
top of the fuel lift pump depressed during a few
seconds. The engine will stop immediately, by lack of
fuel supply.
Start / Stop
Engine operation 10
19craftsman marine diesel engines CM2.12 , cm2.16 / cm3.27
To Next Page
