Engine lubrication oil
11 Maintenance and inspection
Changing of the engine lubrication oil
Remove the dipstick first. Then insert the hose of the
special sump pump into the pipe of the dipstick.
Extract the oil from the engine by quickly pushing
down the grip of the sump pump and then pull it
slowly upwards.
Fitting the oil lter
When all lubricating oil has been drained, replace the
oil filter. A little more oil may then come out of the
engine. Collect this oil in a beaker or bowl and bring it,
with the rest of the used oil, to the service station, all
in accordance with the environmental directives.
Replacing the oil must take place when
the engine has its operating temperatu-
re (but is stopped, of course), so that the
fluid can be pumped out easily. The oil
temperature is then about 80 degrees
Celsius, so watch out for burning the
skin !
Replace the engine lubricant and the oil filter after
every 100 hours of service or at least once a year.
Preparation of the new oil lter
Clean the surface of the rubber ring in the rim of the
oil filter and grease it with fresh engine lubrication oil.
26 craftsman marine diesel engines CM2.12 , cm2.16 / cm3.27
To Next Page
