EasyManua.ls Logo

Craftsman CM2.16 - Engine Overheating, Oil Pressure, and Consumption

Craftsman CM2.16
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem Probable cause Solution
6.
Engine becomes
overheated
• Level of cooling liquid too low
• Raw water seacock closed
• Raw water strainer clogged
• Leakage in raw water entry system
• Defective thermostat
• Cooling liquid pump defective
• Defective impeller of raw water pump
• Defective injector / injector pump
• Oil level too high
• Oil level too low
• Defective oil filter
• Check/top up
• Check and open
• Check / clean
• Check/ replace
• Check / replace
• Check / replace
• Check / replace
• Check and clean or replace if necessary
• Lower oil level
• Top up / Replace
7.
Not all cylinders are perfor-
ming well
• Air in the fuel system
• Fuel filter clogged up by water and/or dirt
• Leakage in fuel supply line or fuel injection line
• Defective injector / injection pump
• Fuel line clogged
• Defective glow plugs
• Incorrect valve tolerance
• Filter of electrical fuel lift pump clogged
• Defective electrical fuel lift pump
• In all these cases, please consult your authori-
zed dealer and ask him to solve the problem
8.
Engine has little or no oil
pressure
• Oil level too low
• Clogged oil filter
• Defective oil pump
• Excessive inclination angle of engine
• Incorrect SAE-specification or quality of lubrication oil
• Oil pressure apparently too low on account of defective oil pressure
switch,sensor or gauge
• To up till corect oil level
• Replace
• Repair / replace
• Check / adjust alignment
• Replace by good quality engine lubricating oil
• Replace defective component
9.
Engine oil cumsumption
excessively
• Oil level too high
• Excessive inclination angle of engine
• Incorrect SAE-specification or quality of lubrication oil
• Leakage in lubrication oil system
• Excessive wear and tear to cylinder or piston
• Insufficient supply of combustion air
• Overload of engine
• Lower the oil level
• Check / adjust alignment
• Replace by good quality lubricating oil
• Repair / replace
• Check compression; overhaul engine, if needed
• Check air inlet and ventilation openings in
engine room
• Check the dimensions of the boat propeller
14 Problems and solutions
38 craftsman marine diesel engines CM2.12 , cm2.16 / cm3.27

Table of Contents