Page 19
SNACK/REFRESHMENT CENTER PROGRAMMING GUIDE
1670002
April, 1999
SPECIAL DISPLAY CHARACTERS
Under certain circumstances, the letters in the display will be replaced by
these special characters:
Tray letter (E or F) = Column not empty; not coupled
- = Empty switch ON, 1 can left, not coupled (8 select
can only)
+ = Not empty, coupled to the selection on the right
# = Empty switch ON, 1 can left, coupled (8 select can
only)
(blank) = Empty, not coupled
? = Empty, coupled
(trailing decimal point) = Motor is home
(leading apostrophe) = Motor is jammed
SOME FINAL NOTES:
Make sure the coupled selections are set to the same price.
You cannot couple between rows E and F. Coupling is disabled in TEST
mode and defaults to direct selection.
SELECT WHEN THE CAN UNIT GOES OUT OF SERVICE
(8 SELECT CAN UNIT ONLY)
1. Press , then press until the display shows either
E
+
F OFF
@
0
OR
E
+
F OFF
@
1
2. OFF @ 0 means that each can selection will go out of service when the last
can is vended. OFF @1 means that one can is left when the unit goes out
of service.
3. Press to switch between the two choices.
4. Press until you have left the function.
NOTE
Do NOT manually remove cans from the can unit.
To Next Page
Loading...
Need help?
General
