Creality CR-3040 Pro - Page 7

Start the 3D Printer 启动3D打印机
1
x 1
3D printer｜打印机
3
x 1
Power cord ｜电源线
10
Turn the power switch to the I position to start the equipment.将电源开关拨至I档，即启动设备。
10
1. 开启时铰链自动支撑上门板；
2. 关闭时需用手往外拉铰链即可关闭上门板。
1. The hinge automatically supports the door
panel when opening;
2. Hold the door panel and move the hinge
outward to close it.