7
9
Insert the short PFTE tube included in the kit while pressing the press fitting, make sure it goes all
the way in (to the nozzle) as otherwise it will be difficult to connect the PETG adaptor and extruder
motor to the carriage – and it can give you problems with your extrusion. If your printer has been
used to print before you make this modification and the Bowden tube was not properly in place, then
there can be filament stuck inside the red heat sink which should be cleaned out before attempting
this modification. This is a crucial step and proper cleaning should not be neglected.
10
Now find the PETG adaptor and gently insert the two short screws you unscrewed in step 6 as show
below. Do not use force to avoid breaking the PETG adaptor.
To Next Page
Loading...
