Name: Creality Ender
Brand: Creality
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Put the spacer, wheel and bolt back on the big bolt.

Tighten the big bolt gently, making sure that the carriage can move freely, while at the same time

not being too loose. Assuming your printer was working fine before you made this modification,

then you can use one of the other big wheel bolts as a reference for getting the tightness right.

Questions and Answers:

Need help?

Do you have a question about the Creality Ender and is the answer not in the manual?

Creality Ender Specifications

General