Crest Audio CR4 - Scuba Mode Settings: Alarms; Depth and Dive Time Alarms

Page 26
1.4.2 Scuba Mode Settings
WARNING:
Please make sure you fully understand
that changing this setting will affect
algorithm calculations and the related
risks.
Description: SCUBA Depth Alarm
Settings (SDPTH-ALM) – ON / OFF
To Access: Under Scuba Preview Mode,
press UP Button Or from SETTINGS,
press UP Button / DOWN Button to locate
the cursor at SDPT-ALM and then press
MODE Button to select.
One of the two options will be blinking at
the bottom. Press UP Button / DOWN
Button to select and press MODE Button
once to accept your selection. If you set
the SDPTH-ALM on, when you reach the
preset depth, the alarm will activate.
Default: ON
Setup range:
ON / OFF
Description: SCUBA Dive Time Alarm
Settings (STIME-ALM) – ON / OFF
To Access: Under Scuba Preview Mode,
press UP Button Or from SETTINGS,
press UP Button / DOWN Button to locate
the cursor at STIME-ALM and then press
MODE Button to select.
One of the options will be blinking at the
bottom. Press UP Button / DOWN Button
to select turning the Scuba Time Alarm
either ON or OFF. Press MODE Button to
accept your selection. If you set the
STIME-ALM on, when you reach the
preset time, the alarm will activate.