Crest Audio CR4 - Freediving Mode Settings: Surface Interval and Time; Surface Interval and Time Alarm Settings

Page 34
1.5.2 Freediving Mode Settings
Description: Freediving Surface Interval
Alarm
To Access: Under Freediving Preview
Mode, press UP Button Or from
SETTINGS, press UP Button / DOWN
Button; until the cursor aligns with FSI-
ALM. Press MODE Button once.
One of the FSI-ALM options will be blinking
at the bottom. Press UP Button / DOWN
Button to select other options as needed.
Press MODE Button to accept your
selection. If you set the FSI-ALM on, when
you reach the preset time, the alarm will
activate.
Default: ON
Setup range:
ON / OFF
Description: Freediving Time Alarm
Setting
To Access: Under Freediving Preview
Mode, press UP Button Or from
SETTINGS, press UP Button / DOWN
Button; until the cursor aligns with FTIME-
THD1 to FTIME – THD3. Press MODE
Button once.
One of the FTIME-THD1 options will be
blinking at the bottom. Press UP Button /
DOWN Button to select other options as
needed. Press MODE Button to accept
your selection. If you set the FTIME-ALM
on, when you reach the preset time, alarm
warning will activate: long beeping
repeated three times with vibration.
Default: 30 seconds, 60 seconds, 90
seconds.
Setup range:
0 seconds – 360 seconds