Crestron AMP-2210S/3210S Commercial Power Amplifiers
Commercial Power Amplifiers,
4/8: AMP-2210S/3210S
Introduction
Crestron
®
AMP-series Commercial Power Amplifiers provide a perfect combination
of high output and efficiency for all types of professional audio applications. 100%
Crestron engineered and built, these amplifiers are ENERGY STAR
®
qualified to
enable organizations to fulfill their green initiatives without compromising audio
performance. Advanced design features include a high efficiency amp topology with
active power factor corrected power supply, delivering a generous amount of power
in a space saving 1U rack-mountable chassis.
The AMP-2210S provides two channels of amplification (the AMP-3210S provides
three). Each channel is rated for 210W @ 4Ω or 120W @ 8Ω, and channels 1 and 2
may be bridged together to deliver a robust 420W @ 8Ω to a single load.
The AMP-2210S and AMP-3210S are functionally identical. For simplicity within
this guide, the term “AMP2210S/3210S” is used except where noted.
Features and Functions
ENERGY STAR
®
qualified power amplifier
Ultra-efficient space saving design
Low total cost of ownership
High output, low noise, low distortion performance
Two or three channels, each rated 210W @ 4Ω and 120W @ 8Ω
Channels 1 and 2 bridgeable for 420W @ 8Ω
Individual channel power control via jumper or remote contact
Auto power down after 30 minutes of no signal
Instant auto power on when a signal is detected
No inrush current during power up
Over current and DC offset protection per output
Thermal protection on the power supply and each channel
Front panel signal, clip, and fault indicators per channel
Professional balanced inputs
Detachable terminal block connectors
Rear panel ±10 dB input level controls
Convection cooled - no noisy fans
Single space 1U rack mountable
Lightweight and under 11 inches deep
Universal power supply with active power factor correction
Operations & Installation Guide – DOC. 7251A Commercial Power Amplifiers: AMP-2210S/3210S 1
To Next Page
Loading...
