Crestron DigitalMedia Room Controller DM-RMC-100 User Manual

DigitalMedia™ Room Controller, CAT Crestron DM-RMC-100
Connectors, Controls & Indicators (Continued)
# CONNECTORS
1
,
CONTROLS &
INDICATORS
DESCRIPTION
3 VIDEO LED (1) Red/green dual color LED,
indicates video signal presence
and lock status:
Red – indicates no video
Green – indicates the device is
receiving video
Blinking Red/Green –
indicates errors in the video
stream
4 CNTRL LED (1) Red/green dual color LED,
indicates Ethernet connection
and control system
communication status:
Red – indicates no Ethernet
link
Green – indicates Ethernet link
and connection to control
system
Blinking Red/Green –
indicates Ethernet link but no
connection to control system
Blinking Green - The LED
goes out momentarily every
time a control command is sent
or received (i.e. IR, RS-232,
Relay, Sens)
5 SETUP (LED and
Button)
(1) Red LED and (1) miniature
recessed push button, for
Ethernet auto-discovery and
default IP address
(Continued on following page)
14 • Room Controller, CAT: DM-RMC-100 Operations & Installation Guide – DOC. 6743-1F

Crestron DigitalMedia Room Controller DM-RMC-100 Specifications

General

Category	Controller
Type	DigitalMedia Room Controller
HDMI Output	1 HDMI output
Ethernet	10/100 Mbps; auto-switching
Control System	Crestron
Operating Temperature	32° to 104° F (0° to 40° C)
Humidity	10% to 90% RH (non-condensing)
IR/Serial	Yes
Relay	Yes
USB	Yes
DM 8G+ Input	1 DM 8G+ input
Analog Audio Output	1 analog stereo output
IR/Serial Port	1 IR/Serial port
Relay Port	1 relay port
USB Port	1 USB port
Input Connectors	DM 8G+
Output Connectors	HDMI, Analog Audio, IR/Serial, Relay
Audio Support	Stereo
Storage Temperature	-4°F to 140°F (-20°C to 60°C)