DigitalMedia Presentation Systems Crestron DMPS-100/200/300-C/300-C-AEC
38 • DigitalMedia Presentation Systems: DMPS-100/200/300-C/300-C-AEC Operations Guide – DOC. 7219D
IP Configuration
In Static IP Address mode, devices connected to the DMPS-100/200/300-C receive a
static IP configuration equivalent to the DMPS-100/200/300-C IP address plus their
slot number. This configuration is sent when the DMPS-100/200/300-C starts up.
1. Turn off DHCP
2. Set the IP Mask
3. Set the default router
4. Set the IP address
Refer to the following table. In this example, the user assigns the
DMPS-100/200/300-C a static address (the main address). All other connected
device addresses are configured in the following manner.
Static IP Address Configuration of DMPS-100/200/300-C Inputs/Outputs
DMPS-100/200/300-C INPUTS/OUTPUTS IP ADDRESS
DMPS-100/200/300-C (main address) 192.168.1.100
Audio Board No IP address
Video Board (main + 1) 192.168.1.101
DMIn 6 = Video board + slot# = (main +2) + 6 = main + 7 192.168.1.107
DMIn 7 = Video board + slot# = (main +1) + 7 = main + 8 192.168.1.108
DMOut 3 = Video board + slot# = (main +1) + 19 = main + 20 192.168.1.120
DMOut 4 = Video board + slot# = (main +1) + 20 = main + 21 192.168.1.121
Private Network mode (PNM) is supported on all DMPS models. When Private
Network mode is enabled, the main board [control board] takes an IP address and so
does the video board. In Static IP mode, the user may set the IP address of the main
board, and the video board will take that IP address + 1 (just as with PNM disabled).
All downstream TX and RMC devices will be hidden behind the IP address of the
video board.
DMPS Tool
In the Crestron Toolbox Address Book, select the DMPS-100/200/300-C. Then use
the DMPS Tool to configure EDID, HDCP or to troubleshoot AV on the
DMPS-100/200/300-C. Refer to the help file for additional information.
DMPS Tool
To Next Page
Loading...
Need help?
General
