Isys
®
8.4” WiFi Touch Screen Crestron TPMC-8X-GA
NOTE: In order to configure the wireless network using the following procedures,
make sure the Use Window to configure my wireless network settings checkbox is
checked. If using the TPMC-8X-GA Security Pack, make sure this is not checked.
NOTE: The link at the bottom of the window, which says “Learn about setting up a
wireless network configuration” is not supported at this time.
There are two ways to configure the wireless network: via the wizard and manually.
Configure via the Wizard
To configure your wireless network using the Wireless Network Setup Wizard,
complete the following procedure:
1. From the Wireless Networks tab, touch View Wireless Networks to view
the “Wireless Network Connection” window.
“Wireless Network Connection” Window
2. Touch Refresh network list to scan for available access points.
NOTE: Depending on network settings, the “Wireless Network
Connection” window may not show any networks. In this case, configure
the network manually. (Refer to “Configure Manually” on page 31.)
3. Select the desired network and touch Connect to open the second “Wireless
Network Connection” window.
30 • Isys
®
8.4” WiFi Touch Screen: TPMC-8X-GA Operations Guide – DOC. 7078C