Crestron TSW-760 - Gingco.net

Product Manual — Doc. 7927K TSW-560, TSW-760, and TSW-1060 • 69
5. Reboot the touch screen. The EMS user interface is displayed on the touch screen following
the reboot.
EMS User Interface
6. Enter the required EMS Software account information:
NOTE: Profiles and rooms must be set up on the network through an EMS Software
account prior to selecting them in the application.
a. Use the Profile drop-down menu to select the profile that will be used with the touch
screen.
b. Use the Room drop-down menu to select the room that will be used with the touch
screen.
c. Tap Apply.
If the device is registered successfully, the application switches to a scheduling interface for the
room.
For more information on using the EMS Software application, including adding and configuring a
scheduling calendar, visit https://portal.emssoftware.com/s/.
For technical support inquiries, visit https://portal.emssoftware.com/s/support.
Gingco.net
To set up the Gingco.net scheduling application on the touch screen:
NOTE: A Gingco.net/Estate account is required to use this application. For more information,
visit www.gingco-estate.com/en/home/.