Converting the Croozer Cargo to a Bicycle Trailer
The tension-adjusting nut must engage the threads for at
least five full turns in order to ensure adequate clamping
force for holding the rear wheel securely. Failure to tighten
the tension-adjusting nut adequately may result in accidents
with serious injury or death. If the quick-release skewer is
too short, it must be replaced. Consult a professional bicycle
mechanic for the appropriate parts and assistance.
7. Hold the rear wheel with both hands, and try to rock it
back and forth to check that the quick-release mecha-
nism is securely fastened. If there is any play in the
wheel, repeat steps 5 and 6.
It is vitally important that the rear wheel with the hitch
be installed correctly. Riding with an incorrectly installed
rear wheel could result in accidents with serious injury or
death. Follow the instructions and warnings given in the
owner’s manual of the towing bicycle. When in doubt,
consult a professional bicycle mechanic.
Installing the axle hitch to a bicycle with a solid axle
1. Remove the nut (1) on the left side of the solid axle by
turning it anticlockwise.
It is vitally important that you leave the existing washer on
the axle. This washer prevents the axle from rotating in
the dropouts. Riding without the axle washer can result in
accidents with serious injury or death.
2. Without removing the retaining washer, place the axle
hitch (3) onto the axle by feeding the end of the axle
through the hole in the hitch.
3. Screw the nut (1) back onto the axle, tightening lightly
at rst.
To ensure adequate clamping force, the axle nut must
be tightened onto the threads of the axle by at least 5 full
turns. If it is not possible to tighten the nut at least 5 full
turns, then the axle is too short, which could allow the
rear wheel or hitch to come loose, resulting in accidents
with serious injury or death.
When in doubt, consult a professional bicycle mechanic!
4. Check that the rear wheel is properly centred, adjust-
ing the position if necessary; then tighten the nut (1)
using the tightening torque specied in the owner’s
manual of the bicycle.
5. Finally, hold the rear wheel with both hands and try to
rock it back and forth to check that the wheel is held
securely in the dropouts.
The rear wheel must be properly attached after the
axle hitch has been installed. Riding with an improperly
installed rear wheel can result in accidents with serious
injury or death. Follow the instructions and warnings
given in the owner’s manual of the towing bicycle. When
in doubt, consult a professional bicycle mechanic.
min. 5 x
Nm
3
1
2
1
3
To Next Page
Loading...