Crown 2/600 - Crossover Settings

Page 16
CDi DriveCore Series Operation Manual
Conguring the Amp
Configuring Output Modes
From the Output Mode Setup screen (see Figure 16), outputs can be configured for Low
Z or High Z operation. By default, the CDi DriveCore amplifiers are configured for Low Z
operation on all outputs.
To congure output mode settings:
1� From the Home screen, press the MENU button.
2� Select the "Configure Amplifier" option from the menu using the ENCODER.
3� Select the "Output Mode (70V/100V)" option from the menu.
4� Use the ENCODER to navigate, make selections, and edit settings.
5� When done, select "Done" at the bottom of the screen.
Available options:
• LoZ, 70V, 100V
Configures the output for the application type. Select the "LoZ" option for conventional low-impedance (2/4/8Ω) passive speakers, or choose the
appropriate voltage setting if configuring the output for a high-impedance (contsant-voltage) install application.
NOTE: If a pair of outputs are configured for bridge mono operation, selecting the 70V option will provide 140V and selecting the 100V option will
provide 200V.
For additional information on output modes and configuring output mode settings in Audio Architect, see "Conguring Amp Wiring & Output
Modes in Audio Architect" on page 36.
Configuring DSP
From the Edit DSP menu (see Figure 17) you can manually edit crossover, delay, and
limiter settings to optimize the loudspeakers. Note that this screen shows the status of each
DSP module (block). When a module is darkened, it is bypassed. When a module is bright,
it is turned on.
To manually edit DSP settings:
1� From the Home screen, press the MENU button.
2� Select the "Configure Amplifier" option from the menu using the ENCODER.
3� Select the "Edit DSP" option from the menu.
4� Use the ENCODER to select the module you wish to edit.
5� Use the ENCODER to navigate, make selections, and edit settings.
6� When done, select "Done" at the bottom of the screen.
Figure 16: Output Mode Setup screen
Figure 17: Edit DSP screen