Page 21
CDi DriveCore Series Operation Manual
Installing Audio Architect & Conguring the Network
Installing Audio Architect & Conguring the Network
Introduction to HiQnet Audio Architect
CDi DriveCore amplifiers can be set up from either the front panel or from the HiQnet Audio Architect software program. Access to some settings and
functionality are only available from Audio Architect.
The latest version of Audio Architect can be downloaded at www.audioarchitect.harmanpro.com/en-US/software. To communicate with Audio Architect, the
amplifier must be connected to a TCP\IP network via the rear panel Ethernet port and, in some cases, configured for the network.
NOTE: The BLU link ports available on BLU link CDi DriveCore models cannot be used for network control and monitoring of the amplifier.
When Audio Architect is first loaded, the software will scan the network for HiQnet devices. All devices that are discovered on the network will be found
under the Device Tree menu in the left-hand side of the Main Audio Architect window (see
Figure 22).
Figure 22: Device Tree menu
NOTE: If devices are not discovered and displayed in the Device Tree menu as shown above, the device and/or network may not be configured correctly.
See "Conguring Amplier Network Settings" on page 22 for information on configuring network settings.
To Next Page
Loading...
