Cryo-con 24C - Page 123

Cryo-con Model 24C Remote Programming Guide
Autotune Commands
LOOP {1 | 2 | 3 | 4}:AUTotune:STARt
LOOP {1 | 2 | 3 | 4}:AUTotune:EXIT
LOOP {1 | 2 | 3 | 4}:AUTotune:SAVE
LOOP {1 | 2 | 3 | 4}:AUTotune:MODe {P | PI | PID}
LOOP {1 | 2 | 3 | 4}:AUTotune:DELTap <num>
LOOP {1 | 2 | 3 | 4}:AUTotune:TIMeout <num>
LOOP {1 | 2 | 3 | 4}:AUTotune:PGAin?
LOOP {1 | 2 | 3 | 4}:AUTotune:PGAin?
LOOP {1 | 2 | 3 | 4}:AUTotune:DGAin?
LOOP {1 | 2 | 3 | 4}:AUTotune:STATus?
OVERTEMP commands
OVERtemp:ENABle {ON | OFF}
OVERtemp:SOURce {A | B | C | D}
OVERtemp:TEMPerature <temp>
Sensor Calibration Curve Commands
CALcur
SENSor <index>:NAMe name string"
SENSor <index>:NENTry?
SENSor <index>:UNITs {VOLTS | OHMS | LOGOHM}
SENSor <index>:TYPe { DIODE | ACR | PTC100 | PTC1K |
NTC10UA | ACR | TC70 | NONE }
SENSor <index>:MULTiply <multiplier>
Relay Commands
RELays? {1 | 2}
RELays {1 | 2} :SOURce {A | B | C | D}
RELays {1 | 2} :MODe {auto | control | on | off}
RELays {1 | 2} :HIGHest <setpt>
RELays {1 | 2} :LOWEST <setpt>
RELays {1 | 2} :DEADband <deadband>
RELays {1 | 2} :HIENa { YES | NO }
RELays {1 | 2} :LOENa { YES | NO }
PID Table Commands
PIDTable? <num>
PIDTable <num>:NAMe Name String"
PIDTable <num>:NENTry?
PIDTable <num>
PIDTable <num>:TABLe
117