Cryo-con 24C - EU Declaration of Conformity

Cryo-con Model 24C Remote Programming Guide
SENSorix <index>:UNITs {VOLT| LOGOHM | OHMS}
Sets or queries the units of a user installed calibration curve at <index>. For
information on the curve units, refer to the User Calibration Curve File Format
section.
SENSorix <index>:
TYPe {DIODE | ACR | PTC100 | PTC1K | TC70 | NTC10UA}
Sets or queries the type of sensor at <index>. For more information on
sensor types, please refer to the Input Configurations section. Index is 0
through 7.
SENSorix <index>:MULTiply <multiplier>
Sets or queries the multiplier field of a user installed calibration curve at
<index>. For information on the multiplier, refer to the User Calibration Curve
File Format section.
133