Operating Instruction and Documentation
CSL640/641
- 4 – TES1518/E
Organisation requirements
- The instructions for use are constantly to be kept at the place of operation being at hand
at any time.
- In addition to the instructions for use, rules pertaining to other regulations i.e. accident
prevention and environmental rules are to be observed and directed.
- All personnel should be safety and danger alert by occasionally reading and by observing the
instructions for use which should be recorded.
- As far as required and ordered by regulations personal protective equipment and clothes are to
be worn.
- All safety- and danger-warnings on or near the lift are to be observed!
- Spare parts must comply with technical requirements laid down by the manufacturer.
This is only warranted with original parts.
Consideration should be given to the time intervals or fixed in instructions for periodic
tests/inspections.
Maintenance works, remedy of faults and disposal
- Fixed Adjusting-, maintenance- and inspection works and time intervals including
Details for exchange of parts/part components as mentioned in the instructions for use are to be
adhered to.
This work should only be carried out by trained personal.
- After maintenance and repair works, all screw connections should be checked and
tightened where required.
Guarantee and liability
- Our “General conditions of sales and delivery” are valid.
There will be no guarantee or liability for injuries of persons or anything else if these injuries are
caused by one or by some of the following reasons.
- Inappropriate use of the lift
- Inappropriate installation, initiation, operation and maintenance of the lift.
- Use of the lift while one or several security devices do not work or do not work correctly or are not
installed correctly.
- Not to follow the regulations of the operating instruction concerning transport, storing, installation,
initiation, operation and maintenance of the lift.
- Changes to the construction of the lift without written authority from the manufacturer.
- Changes of important adjustments of the lift (e.g. driving elements, power rating, motor speed, etc)
- Wrong or incorrect maintenance.
- Catastrophes, acts of God or external reasons.
To Next Page
Loading...
Need help?
General
