Operating Instruction and Documentation
CSL640/641
- 49 – TES1518/E
5.6 Function test before first use.
• Before working with the play detector, carry out functionality test.
• Behind the operating unit is an additional switch with three positions.
• Remove the rear upper cover of the operating unit.
Test the function of the individual play detector plates.
Pos. “0” - This is the Position for the normal function
Pos. “1” - Plate 1 of the play detector is moveable.
Press the button of the hand lamp. The plate starts the cycle until the
button is pressed again.
Pos. “2” - Plate 2 of the play detector is moveable.
Press the button of the hand lamp. The plate starts the cycle until the
button is pressed again.
• After testing, set the switch on Position “0”.
6. Troubleshooting
If the lift is not working properly, the reason might be quite simple. Please check the lift for the
potential reasons mentioned on the following pages. If the cause of trouble cannot be found,
please call the technical service department on 0844 665 7610.
Repairs to the lift’s safety devices as well as repairs and examinations of the electrical
fittings may only be performed by specialists.
Problem: Motor does not start!
Potential causes:
No power supply
Main switch is not engaged
The main switch is defective
Fuse defective
The feed line is cut
Thermal switch in the motor is active
Motor is defective
solution:
Check the power supply
Check the main switch
Check the main switch
Check Fuse
Check the complete cable
Let motor cool down
Call technical service
To Next Page
Loading...
Need help?
General
