Operating Instruction and Documentation
CSL640/641
- 61 – TES1518/E
Secure the lift against swinging and overturning by appropriate means in order to
eliminate the danger of accident.
• Tie the ground plates to the platforms.
• Disconnect electrical wires, hydraulic hoses and air hoses.
• Transport the lift to its new location.
• Install the lift according to these regulations.
Use new dowels. Used dowels have been mechanically stressed and MUST not be
used.
A security check must be performed by a competent person before reinitiating. Use
form “Regular security check”.
• If necessary, carry out a reset before the first operation. (see chapter 6.3)
• Raise the lift to a height of about 800 mm.
• Mount the lifting arms.
• Raise and lower the lift several times without a load (vehicle) to the upper and lower limits.
• Check that the safety devices are functioning correctly.
• Raise and lower the lift several times with a vehicle to the upper and lower limits. (see
chapter 5.2)
• Check the hydraulic system for leakages.
• Check that the masonry-bolts are correctly torqued again.
In the case of any faults, call Customer Service immediately!
To Next Page
Loading...
Need help?
General
