STEP 3. COMISSIONING
On power-up, the DualCom Pro will automatically contact the Gemini Global Platform to perform its
commissioning process, which will take up to 5-8 minutes. During this time the display will show ‘N’ to indicate
it is a new device, followed by ‘C’ as commissioning is in progress and ‘R’ to indicate it is fully commissioned and
ready for use.
During this process you may see ‘SIM NOT READY’ displayed. This is normal and will clear once completed.
LED 1– POWER
LED 2 –
COMMUNICATION PATH
LED 3 – COMMISSIONING
No light = The
DualCom Pro does
not have power
No Light = No paths working yet or the
DualCom Pro does not have power
No Light = No communication path found
Green Solid Light =
The DualCom Pro is
powered and is
running valid firmware
Amber Solid Light = One communication path
is working
Amber Flashing Light = Communication
path found
Green Solid Light = Two communication paths
are working
Green Flashing Light = Commissioning
Server found, contacting the Alarm Server
Green Solid Light = Fully commissioned
6
Figure 3 - LEDs ON INITIAL POWER UP
LEDs
To Next Page
Loading...
Need help?
General
