122
This page is used to configure LACP function. With LACP protocol, switches can
learn trunk connections automatically.
Follow the steps to do it. (*Don’t connect trunk cables until this function is set.)
a. Enable Trunk function at “Trunk Information” page first. Then click [Apply].
b. Assign System Priority. (Its value is 1~65535 and higher number has lower
priority. Combining with the Mac address of the switch, it is used to identify
this switch in LACP protocol operation.)
c. Select ports that will run LACP protocol.
d. Click [Apply].
Note
: If ports are already in static trunk group, they are not allowed to apply as
LACP ports. If static ports are selected as LACP ports, warning message will be
prompted when [Apply] is clicked.
3). Lacp Port Status
This is for LACP protocol running status.
To Next Page
Loading...
Need help?
General
