44
6.2.4 Interface Configuring Commands
Commands in Configuring Mode are for general switch settings. And its prompt is
“(config)#”.
The port interface function and VLAN group interface function are set with
“interface” command.
(config)# interface ?
ethernet Ethernet port
vlan Switch Virtual LAN interface
interface ethernet 1/x command is used to configure settings for Port x. Please
refer to section
6.2.4.1 Interface Configuring Commands for Port for the
details.
interface vlan x command is used to configure VLAN Group x interface (“x” is
the VLAN ID). Please refer to section
6.2.4.2 Interface Configuring
Commands for VLAN for the details.
Both commands will change the prompt from “(config)#” to “(config-if)#”.
Note: The general VLAN settings are done with “vlan database” command.
Please refer to section
6.2.5 VLAN Configuring Commands for the
details. And
interface vlan x command is used to assign characteristics to a
VLAN interface. For example, assigning IP address to a VLAN interface is done
with this command.
6.2.4.1 Interface Configuring Commands for Port
Commands in Configuring Mode are for general switch settings. And its prompt is
“(config)#”.
If the settings are for ports, it is done with “interface ethernet 1/x” command in
configure mode. For example, “interface ethernet 1/5” is for settings on Port 5.
Some syntax are supported for port selection.
1. interface ethernet 1/x and “x” is port number. All the settings after this
command will be applied to this port. For example, “interface ethernet 1/5” and
all the settings after this command will be applied to Port 5.
2. interface ethernet 1/x,y,z,... and “x”, “y”, “z",.. are port number. All the
settings after this command will be applied to these ports. For example,
“interface ethernet 1/2,4,7” and the settings after this command will be applied
to Port 2, Port 4, and Port 7.
3. interface ethernet 1/x-y and “x”,”y” are port number. All the settings after this
command will be applied to ports in this range. For example, “interface
ethernet 1/4-7” and the settings after this command will be applied to Port 4,
Port 5, Port 6, and Port 7. (Port 4~7)
To Next Page
Loading...
Need help?
General
