24
6.2.2 General Basic Commands
When “admin” / “admin” is used for username/password, the console will enter
administrator mode. Enter “?”, command list will be shown.
---------------------------------------------------------------------------------------------
# ?
exit Exit from current mode
help Show available commands
history Show a list of previously run commands
logout Disconnect
ping Sends ICMP echo packets to other network nodes
quit Quit commands
reload Halts and performs a warm restart
show Shows information
calendar Data and time information
configure Enter configuration mode
copy Copies from one file to another
#
---------------------------------------------------------------------------------------------
1. exit command
This command is used to leave current operation mode. It will do logout at this
basic command interface.
2. help command
This is a help command and the console will prompt with all available
commands.
3. history command
This command will show the history of entering commands.
4. logout command
This is a logout command.
5. ping command
User can use this command to ping another network device to verify the
network connection and activity. (It is similar to the ping command in MS-DOS.)
Enter “ping ?” at the prompt, the command syntax will be shown.
# ping ?
Syntax: ping [-n count] [-l length] [-t] [-w timeout] ip
To Next Page
Loading...
Need help?
General
