25
-n count : Number of echo requests to send.
-l length : Send buffer size, and length is between 64~8148
-t : Ping the specified host until stopped by <ESC> key.
-w : Timeout in milliseconds to wait for each reply.
ip : IP address (xxx.xxx.xxx.xxx)
For example, “ping 192.168.1.80”. “Esc” can be used to break continuous ping
operation.
6. quit command
This command is used to quit the console interface.
7. reload command
This command is used to reset switch. It will halt and perform a warm restart.
Enter “reload” at the prompt, you will be asked to confirm the action.
# reload
Are you sure to reset switch now?(Y/N)
If “y” is entered, the switch will reboot. If “n” is entered, just leave and no any
action will go.
8. show command
This command is used to show current system information and system
configuration.
Enter “show ?” at the prompt, the sub-command list will be shown.
# show ?
aaa Show AAA service configuration
calendar Date and time information
dhcp-relay DHCP Relay Configuration
dot1x 802.1x content
gvrp GVRP configuration
history History information
interface Interface information
ip IP information
ip-filter IP Filter Configuration
lacp LACP statistics
line TTY line information
log Log records
mac-address-table Configuration of the address table
mac-security MAC Security Configuration
management Management IP filter
map Maps priority
mvr Show MVR Status
port Port characteristics
queue Priority queue information
radius-server RADIUS server information
running-config Information on the running configuration
rate-limit Configures rate-limits
To Next Page
Loading...
