23
configure mode. And the prompt will become “(config-if)#”. For example,
“interface ethernet 1/5” is for settings on Port 5.
If the settings are for VLAN group, it is done with “interface vlan x” command in
configure mode. And the prompt will become “(config-if)#”. For example,
“interface vlan 100” is for settings on VLAN 100.
4. VLAN Configuring Commands
If the settings are general VLAN settings, it is done with “vlan database”
command in configure mode. And its prompt will become “(config-vlan)#”.
To Next Page
Loading...
