22
---------------------------------------------------------------------------------------------
> ?
exit Exit from current mode
help Show available commands
history Show a list of previously run commands
logout Disconnect
ping Sends ICMP echo packets to other network nodes
quit Quit commands
show Show the counters that the system uses
>
---------------------------------------------------------------------------------------------
In guest mode, it is allowed to view the switch configuration only. No setup/
configure commands are supported.
<< Function Keys >>
Here is the function keys for console interface.
[Tab] key: this key can help to get the full command keyword with just several
beginning letters. For example, “cal-Tab” will get the full “calendar” command
word.
[Esc] key: this key can use to break message display and go back to command
prompt.
[Up-Arrow] key: this key can get last input command.
[Down-Arrow] key: this key can get next input command.
[Left-Arrow]/[Right-Arrow] key: the key can move the cursor.
[Backspace] key: this key can delete the letter in front of cursor
[?] key: this key can get the command list.
<< Command Mode >>
There are four command modes for console interface.
1. General Basic Commands
These are basic commands after login. Users can show switch
configuration/status, ping network device, reboot switch, ... The prompt is
“xxx#” for admin user, and “xxx>” for guest user.
2. Configure Mode Commands
With “configure” command, user can enter Configure Mode. Commands in
Configuring Mode are for general switch settings. And its prompt is
“(config)#”.
3. Interface Configuring Commands for Port / VLAN Group
If the settings are for ports, it is done with “interface ethernet 1/x” command in
To Next Page
Loading...
Need help?
General
