27
The operation of configure mode will be described in next section.
“exit” command can be used to quit this operation mode.
11. copy command
This command is used to backup system configuration/firmware to TFTP server,
restore system configuration from TFTP server, and update firmware from TFTP
server.
# copy ?
binary-config Copies binary configuration file
config Copies configuration file
firmware Copies run-time firmware
copy binary-config running-config tftp xxx.xxx.xxx.xxx yyy command is
used to backup current switch running configuration to TFTP Server at IP
“xxx.xxx.xxx.xxx” as file name “yyy” in binary format.
copy binary-config tftp running-config xxx.xxx.xxx.xxx yyy command is
used to restore binary configuration file “yyy” from TFTP Server at IP
“xxx.xxx.xxx.xxx”.
copy config running-config tftp xxx.xxx.xxx.xxx yyy command is used to
backup current switch running configuration to TFTP Server at IP
“xxx.xxx.xxx.xxx” as file name “yyy” in text format.
copy config tftp running-config xxx.xxx.xxx.xxx yyy command is used to
restore text configuration file “yyy” from TFTP Server at IP “xxx.xxx.xxx.xxx”.
copy firmware running-firmware tftp xxx.xxx.xxx.xxx yyy command is used
to backup current running firmware to TFTP Server at IP “xxx.xxx.xxx.xxx” as file
name “yyy” in binary format
copy firmware tftp running-firmware xxx.xxx.xxx.xxx yyy command is used
to update the running firmware file “yyy” from TFTP Server at IP
“xxx.xxx.xxx.xxx”.
To Next Page
Loading...
