33
Note:
1. Setting 802.1x function on ports, use “dot1x” command in interface
configuring mode.
2. Setting for RADIUS server, use “radius-server” command.
Please refer to sections for the commands.
11 end command
This command is used to exit from configure mode.
12 hostname command
This command is used to set the name of the switch in network. This name is
also used as the hostname for SNMP agent function of the switch.
13 interface command
This command is used to entering interface configuring mode. There are two
sub-commands for it - one is “ethernet”, it is for port setting, another is “vlan”, it
is for VLAN groups characteristics setting.
(config)# interface ?
ethernet Ethernet port
vlan Switch Virtual LAN interface
All the port setting commands are put in interface configuring mode - like rate-
limit setting, speed-duplex setting, .... And characteristics settings for VLAN
groups are also done in interface configuring mode - like IP address
assignment.
For example, the console will enter interface configuring mode for Port 5 with
“interface ethernet 1/5” command. And the prompt will become ...
(config)# interface ethernet 1/5
(config-if)#
With “interface ethernet 1/5,6,10-13”, the console will enter interface configuring
mode for Port 5, 6, 10, 11, 12, 13. And all the settings will be applied to those
ports at the same time.
The description of commands in interface configuring mode is put in Section
6.2.4 Interface Configuring Commands. Please refer to the section for the
details.
14 ip command
This command is used to configure some IP-depending functions. Entering “ip
?”, the sub-commands will be shown.
(config)# ip ?
default-gateway Specifies the default gateway
http HTTP server configuration
To Next Page
Loading...
Need help?
General
