41
snmp-server community set xxx command is used to set the community
string of set command for SNMP operation. “xxx” is the community string.
snmp-server contact xxx command is used to set the contact information for
this switch. “xxx” is the contact information string.
snmp-server location xxx command is used to set the location information for
this switch. “xxx” is the location information string.
snmp-server version x command is used to select the SNMP operation
version. “x” could be v1, v2c, v3, v3v2c, v3v2cv1.
The following commands are for SNMPv3 function.
snmp-server username xxx securitylevel y command is used set security
level of user xxx. “xxx” is the user name. “y” could be noauth, auth, or priv.
- “noauth” : no authentication, no encryption
- “auth” : do authentication, no encryption
- “priv” : do authentication and encryption(by DES)
snmp-server username xxx authentication y command is used to set the
authentication manner. “xxx” is the user name. “y” could be md5 or sha.
29 sntp command
This command is used to configure SNTP protocol of the switch.
Entering “sntp ?”, the sub-commands will be shown.
(config)# sntp ?
client Accepts time from specified time server
server Specified one time server
zone Set time zone
dst Config daylight saving time function.
start-time Set start time of daylight saving time
end-time Set end time of daylight saving time
sntp client command is used to enable SNTP protocol. And no sntp client
command can be used to disable it. If it is disabled, the system time will be got
from manual setting.
sntp server x.x.x.x command is used to set the IP address of network time
server for SNTP protocol operation. “x.x.x.x” is the IP address.
sntp zone xxx command is used to set the time zone. “xxx” is the location of
the time zone. With “sntp zone ?”, the locations will be shown.
sntp dst command is used enabled Daylight Saving Time function. And no
sntp dst command can be used to disabled it. Daylight Saving Time function
will set the system time one-hour early than normal time in a period of time.
“start-time” and “end-time” sub-commands can be used to set the time period.
sntp start-time w/x/y/z command is used to set the start time of Daylight
Saving Time.
- “w” is the week number in the month. Its value is 1~5.
- “x” is the day number in the week. Its value is 0~6.
- “y” is the month number. Its value is 1~12.
- “z” is the hour number in the day. Its value is 0~23.
sntp end-time w/x/y/z command is used to set the end time of Daylight Saving
To Next Page
Loading...
Need help?
General
