49
(config-if)# maximum-packet-length ?
1518 max. packet length=1518
1532 max. packet length=1532
9216 max. packet length=9216
9600 max. packet length=9600
17 mdi-mdix command
This command is used to set the MDI/MDI-X mode of port(s). This switch
supports Auto-MDi/MDIX function. And this command can force it MDI or MDI-
X mode. (MDI is for hub/switch cascading. MDI-X is for PC/device connecting.)
mdi-mdix mdi command is used to set the port(s) to MDI mode.
mdi-mdix mdix command is used to set the port(s) to MDI-X mode.
no mdi-mdix command is used to set the port(s) to Auto-MDI/MDI-X mode.
18 mvr command
This command is used to assign the port(s) as source port of IP multicast traffic
or as receiver port of subscribers for some MVR VLAN.
mvr x receiver-port command is used to set the port(s) as the IP multicast
traffic receiver port of MVR VLAN. “x” is the MVR VLAN ID.
mvr x source-port command is used to set the port as the IP multicast traffic
source port of MVR VLAN. “x” is the MVR VLAN ID.
19 no command
This command is used to disable a function or restore a setting to factory
default of the switch.
(config-if)# no ?
channel-group Adds a port to a trunk
description Interface specific description
dot1x Configures 802.1x port-based access control
duplex Configures duplex operation
flowcontrol Enables flow control during autoneg
ip-filter Set ipaddress filter
lacp Configures LACP status
map Maps priority
maximum-packet-length Configures the maximum packet length of the port
mdi-mdix Configures the MDI or MDIX of the port
mvr Multicast VLAN Registration
port Configures the characteristics of the port
port-vlan Configures Port-Based VLAN
power-saving Decrease energy consumption
qos Configuration of QoS
rate-limit Configures rate-limits
shutdown Shuts down the selected interface
spanning-tree Specifies spanning tree configuration