53
speed auto command will set the interface port(s) to auto-negotiation mode.
speed 10 command will set the interface port(s) to 10M speed.
speed 100 command will set the interface port(s) to 100M speed.
speed 1000 command will set the interface port(s) to 1000M(gigabit) speed.
28 switchport command
This command is used to configure some switch function characteristics for the
interface port(s).
(config-if)# switchport ?
acceptable-frame-types Specifies frame type
allowed Configures the VLAN port list
mode Configures the port mode
native Configures the PVID of the port
private-vlan Private VLAN
untag-vid Configures the port untag vid
vlan-stacking VLAN Stacking port mode
[ Accept Frame Type ]
switchport acceptable-frame-types all command is used to allow the
interface port(s) to accept all types of frame.
switchport acceptable-frame-types tagged command is used to allow the
interface port(s) to accept tagged frame only. Other frame type will be rejected.
[ VLAN Port Assignment ]
switchport allowed vlan add x command will add the interface port(s) to
VLAN x. “x” is the VLAN ID and its valid value is 2~-4094.
switchport allowed vlan remove x command will remove the interface port(s)
from VLAN x. “x” is the VLAN ID and its valid value is 2~-4094.
[ VLAN Port Mode Setting for Private VLAN ]
switchport mode private-vlan host command will set the port type of the
interface port(s) in Private VLAN as “host”. “host” port(s) could be for
Community VLAN or Isolated VLAN.
switchport mode private-vlan promiscuous command will set the port type
of the interface port(s) in Private VLAN as “promiscuous”. “promiscuous”
port(s) could be for Primary VLAN or Isolated VLAN.
no switchport mode private-vlan command will set the port type of the
interface port(s) in Private VLAN as “normal”. “normal” port(s) is for normal
802.1Q VLAN operation.
[ VLAN Port Tag/Untag Setting for 802.1Q VLAN ]
switchport mode hybrid command will set the interface port(s) as hybrid
port(s) for 802.1Q VLAN operation. If a port is defined as “hybrid”, it is a tag
port basically. But it will act as an untag port for packets working in VLAN
defined in “Untag VID”. So, it is called a hybrid port.
For example, set Port 5 as “hybrid” and its Untag VID as 10. Port 5 will act as a
To Next Page
Loading...
Need help?
General
