56
This command is used to show the history of entering commands.
4. logout command
This command is used to logout from console interface.
5. quit command
This command is used to quit from console interface. It has the same function
as logout.
6. interface command
This command is used to change to interface port(s) or another interface VLAN
groups for next setup commands.
(config-if)# interface ?
ethernet Ethernet port
vlan Switch Virtual LAN interface
For example,
“(config)# interface ethernet 1/5” will change the setup interface to Port 5 and
all the following commands will be applied to Port 5.
“(config-if)# interface ethernet 1/6-7” will change the setup interface to Port 6-7
and all the following commands will be applied to Port 6-7.
If “vlan” sub-command is used, the setup interface will be changed to some
VLAN groups. For example,
“(config-if)# interface vlan 100” will change the setup interface to VLAN 100 and
all following commands will be applied to VLAN 100.
The description of commands in interface configuring mode is put in Section
6.2.4 Interface Configuring Commands. Please refer to the section for the
details.
7. ip command
This command is used to set IP address of the switch on this VLAN interface.
And only users in this VLAN can access this switch with the IP address
remotely.
(config-if)# ip address ?
dhcp Dynamic host configuration protocol
A.B.C.D IP address
renew Renew IP
release Release IP
ip address dhcp command is used to enable DHCP client function. DHCP
client function will try to get IP configuration from DHCP server in network. And
no ip address dhcp command can be used to disable it.
To Next Page
Loading...
Need help?
General
