67
Password threshold: open-end time
Baudrate: 9600
Databits: 8
Parity : 0 [0|1|2|3][NONE|EVEN|ODD|MARK|SPACE]
Stopbits: 1
12. show log command
This command is used to show current system log and system log configuration.
# show log ?
configuration logging configuration
<cr>
show log command is used to show current system log content.
For example,
# show log
[5] Thu Jan 01 09:00:02 1970
Level: 4 System Started [port 0]
[4] Thu Jan 01 09:08:20 1970
Level: 4 Link down [port 8]
[3] Thu Jan 01 09:07:50 1970
Level: 4 Link up [port 8]
[2] Thu Jan 01 09:07:45 1970
Level: 4 Link down [port 8]
[1] Thu Jan 01 09:00:06 1970
Level: 4 System Started
show log configuration command is used to show current system log
configuration.
For example,
# show log configuration
[System Log]
System Log Status : Enable
Log Level(0-7): 7
Remote Log : Disable
Remote Log Server IP : Empty
Remote Log Server IP : Empty
Remote Log Server IP : Empty
Remote Log Server IP : Empty
Remote Log Server IP : Empty
13. show mac-address-table command
This command is used to set Mac address table and configuration about it.
# show mac-address-table ?
aging-time Aging time for entries in the address table
address Address information
interface Ethernet or port channel-interface
multicast Knowns multicast addresses
<cr>
To Next Page
Loading...
