69
14. show mac-security command
This command is used to show mac address security settings on port. There
are two mac address security functions for ports. One is “accept” function that
allows static mac addresses on ports to access network only. Another is “limit
by mac no.” function and up to a limit number of mac addresses are allowed to
access network from the port.
For example,
# show mac-security
[MAC Security Configuration]
===========================================================
Port# Max. MAC no. Learned no. Security Control
Eth 1/ 1 0 N/A No Security
Eth 1/ 2 0 N/A No Security
Eth 1/ 3 0 N/A No Security
Eth 1/ 4 0 N/A No Security
Eth 1/ 5 10 0 Limited by MAC no
Eth 1/ 6 0 N/A No Security
Eth 1/ 7 0 N/A Accept function
Eth 1/ 8 0 N/A No Security
Eth 1/ 9 0 N/A No Security
Eth 1/10 0 N/A No Security
15. show management command
This command is used to show switch management security settings. The
IP/subnet, access mode, and protocol functions security settings will be shown.
For example,
# show management
[Management IP configuration]
Index Enabled Address / Net Mask Mode Http Telnet SNMP
====================================================================
1 Yes 0.0.0.0/0.0.0.0 Modify Yes Yes Yes
2 No 0.0.0.0/255.255.255.255 View No No No
3 No 0.0.0.0/255.255.255.255 View No No No
4 No 0.0.0.0/255.255.255.255 View No No No
====================================================================
16. show map command
This command is used to show 802.1P priority, DSCP priority, and port-based
priority to priority queues mapping. There are four priority queues on each port
of the switch.
# show map ?
dscp IP DSCP priority map
port IP port priority
priority 802.1p priorities map
show map dscp command is used to show IP DSCP QoS function
To Next Page
Loading...
Need help?
General
