82
About [Daylight Saving Time] ...
Daylight Saving Time function will set the system time one-hour early than normal
time in a period of time. [Start Time] and [End Time] can be used to set the time
period.
4). Log
[Configuration]
Users can configure System Log function and view log records here. If this
function is enabled, the switch will record events to a log file and put the log file to
flash.
Up to 512 records are allowed for local logging. If more than 512 events happen,
the records will be overwritten from beginning. And if remote syslog server is
applied, the switch will also send event record to the syslog server.
About log function configuration ...
System Log Status : This can enable/disable system logging function.
Log Level (0~7) : Log levels 0~7 are defined as below. And events with lower log
level than this number will be recorded.
Level Name Description
0 Emergency System is unusable
1 Alert Action must be taken immediately
2 Critical Critical conditions
3 Error Error conditions
4 Warning Warning conditions
5 Notice Normal but significant condition
6 Informational Informational messages
7 Debug Debug-level messages