CTI 2572-B - Page 81

CTI 2572-B / 2500C-2572-B Installation and Operation Manual 75
HEX
DEC
DESCRIPTION
SOLUTION
0284
644
INCOMPLETE WRITE
The actual number of words written does
not match the requested number of
words.
The actual number of words written is
contained in the response message from
the remote device.
This error is probably caused by an
improperly programmed server node. If the
server is a PLC emulating a 2572-B server,
review the code and correct as required.
If the server is another 2572, contact CTI
028B
651
INVALID IP ADDRESS
The command cannot be used with a
multicast address.
Change the IP address to a unicast address or
change the command to one that supports
multicast.
0290
656
INVALID ADDRESS CLASS
The address class is not supported by the
server
See error 0284 above.
0292
658
MESSAGE ID MISMATCH
The response message contained an ID
field which did not match the ID field in the
command.
This error could be caused by a timeout value
which is too short followed by an attempt to
re-send. Therefore, by the time the response
to the first command arrives, you have
already sent a second command. You may
correct this condition by increasing the
timeout value.
This may also be caused by an improperly
programmed server. If the server is a PLC
emulating a 2572-B server, review the code
and correct as required.
029C
668
ETHERNET TRANSMISSION ERROR
The Ethernet port was unable to send the
packet.
If the problem persists, Contact CTI