2 Installation and Removal of Engine Parts
24
2 Changing of Oil Filter
• First time:
Change after 50 hours of operation
• After second time:
Change after every 100 hours of operation
When changing the oil filter, make sure to check the oil
amount with oil level gauge and supply to satisfy the
required amount.
3 Cleaning of Radiator and Radiator Screen
Reference) Use working gloves.
1. Remove the radiator screen and clean the trash.
2. Check the blinding of the radiator. If blinded,
remove the trash on the front face of the radiator.
Blow the air from the cooling fan side to remove
the refuse.
4 Inspection of Cooling Water
1. The radiator is equipped with a reserve tank to
adjust the cooling water in the radiator
appropriately. Check it before operation and supply
if required.
2. Open the bonnet and check the cooling water in the
reserve tank is within "FULL" (upper limit) and
"LOW" (lower limit).
3. When the cooling water is insufficient, supply it
from the reserve tank.
CAUTION
Check before starting the engine. Take caution
not to burn yourself when opening/closing the
radiator cap.
Toremove To install
GZ3W21-041
Radiator
Radiatorscreen
GZ3W21-042
Reservetank
"FULL"
FULL
"LOW"
LOW
GZ3W21-043
www.mymowerparts.com
K&T Saw Shop 606-678-9623 or 606-561-4983
To Next Page
Loading...
Need help?
General