Installation and Removal of Engine Parts 2
25
5 Changing of Cooling Water
1. Remove the bypass hose and drain the cooling
water.
2. Wash the radiator internal sufficiently by running
and draining the water repeatedly until the water in
the radiator is clean.
Reference) Use the cleaning agent for a better
effect.
3. After draining, install the bypass hose. Fill up the
radiator with water up to the water supply opening
and close the radiator cap.
• Once the engine started, the water will circulate and
the water in the radiator will decrease. Stop the
engine and Supply the water.
Reference) In order to prevent the internal of
engine cooling water parts from corrosion, it is
recommended to add the rust-preventive agent
to the cooling water.
Capacity : 5.5 L {1.5 gal}
6 Cleaning of Air Cleaner
If used an unclean air cleaner element, the engine output
will deteriorate.
1. Remove the air cleaner cover and remove the
element.
2. Clean the element and valve of the air cleaner
cover.
Bypasshose
GZ3W21-044
Radiatorcap
GZ3W21-045
Aircleanercover
Valve
Aircleanerbody
Element
GZ3W21-046
www.mymowerparts.com
K&T Saw Shop 606-678-9623 or 606-561-4983
To Next Page
Loading...
Need help?
General