14
NOTE: It is recommended that (3) people assist in
mounting the container. With three people available, two
can lower the container onto the frame while the third
person inserts the pivot pins P#(K0172) through the
holes. Insert the pins from the outside to the inside.
Secure with (1) 5/8” washer P#(K0058) and (1) 5/32” x
2-5/8” hair pin clip P#(K0088) per pivot pin (Figure 2-
12b). Reattach the bottom ends of the door opening
linkages to the main frame by using (1) Rue-Ring cotter
pin P#(K1437) per side. To test the functionality of the
dump mechanism, pull the lift handle away from the unit,
and lift upward. The door of the container should open
and the box should pivot clockwise towards the ground.
2-12 Aluminum Grass Container
Installation
The linkage may be adjusted in two places, at the
adjusting screw P#(K1435) and the latch assembly
items. See page 21 for visual clarification. To change the
door closure tightness, thread the adjusting screw
(Figure 2-13) in or out. To adjust the latch, change the
length of the latch rod by threading the latch adjusting
ball joint in or out. The latch hook pivot should be in the
middle of the slot in the latch hook pivot plate. Slide the
pivot back or forth and then re-tighten.
2-13 Dump Mechanism Adjustment
Rue-Ring
Cotter Pin
Adjustment
Screw
Figure 2-13
Figure 2-12b
Washer
Hair Pin
Clip
Pivot
Pin
Attach
Here
Figure 2-12a
Box Assembly
To Next Page
Loading...
