29
Repair or replace before the next use. Any
replacement component installed during repair shall
frequently checked for necessary replacement. Any
replacement bag should be checked to ensure
2. Inspect the unit for worn or damaged components.
by the manufacturers to be affixed to the component.
compliance with the original manufacturer’s
container, underneath the belt shields, and safety
recommendations or specifications.
decals. Replace any missing or illegible decals.
include the component’s current safety decal specified
3. Under normal usage, the bag material is subject to
After Each Use:
deterioration and wear and should therefore be
1. Clean all debris from machine especially from the
4. Check belt for proper tension.
been torn or worn through, replace immediately.
4. Perform lubrication per instructions.
Correct any deficiency before continuing operation.
3. Make sure all shields are in place and in good
6. With the engine off, engage the blower assembly.
loose parts, damaged bearings, or other damage.
Check the belt tension and inspect the pulley belt for
cracks or tears.
7. Check for wear or deterioration of the upper or lower
hoses. If there are any portions of the hose that have
condition. Repair or replace any missing or damaged
shields.
5. Listen for abnormal sounds, which might indicate
DOCUMENT THE FOLLOWING INFORMATION FOR FUTURE REFERENCE
Unit Engine Size:__________________________________________________
Address: _________________________________ State:_______ Zip:_______
Unit Serial Number:________________________________________________
Phone Number: ____________________________________________________
Unit Model Number:_______________________________________________
Date of purchase:________/________/_________
Dealer/Distributor Name:__________________________________________
New PECO, Inc.
Fax: 828-684-0858
Email: peco@lawnvac.com
10 Walden Dr | Arden, North Carolina 28704
Phone: 1-800-438-5823 | 828-684-1234
Website: www.lawnvac.com
2018 (v2.0)
4-2 Lubrication
NOTE: The following is for older PTO models that
contain maintenance-free bearings and are without
.
lubrication of the shaft on the blower assembly.
SECTION V - PARTS & SERVICE
a greasable fitting.
1. On initial use: Grease the fitting on the blower shaft.
NOTE: Use only white lithium based grease for
5-1 Parts And Service Information
Operators are recommended to check for leaks weekly.
If a leak is observed, both the gasket and the seals are
recommended to be replaced.
Blower Assembly:
Replace the oil using 5.5 oz. of the recommended
Mobilube HD Plus 80W-90 oil. Be sure to not overfill.
contain a greaseable zirc fitting. Newer models
NOTE: The gearbox is filled with 6.0 oz. of Mobilube
HD Plus 80W-90 oil and permanently sealed. There is
no need for scheduled lubrication. The oil level should
only be checked if a leak is observed or if a change in
gearbox noise is noticed.
Gearbox:
2. Every 25 hours of use: Re-grease the grease fitting.
Collection system owners should record the name and
telephone number of their Service Center. Your Service
Center will be happy to supply replacement parts,
accessories, and do any service or repairs to your
collection system. If for any reason your Service Center
is unable to service your collection system or supply
replacement parts, contact New PECO, Inc. and include
the following information on the chart below.
To Next Page
Loading...
Need help?
General
